• If your have CLUB EVENTS/RIDE & would like to announce it here,
    Message traxxas-modifier about it :-)

Search results

  1. Adrian Relato

    Yamaha T135hc Sniper Mx 1rp Service Manual Complete

    i just have question based on the service manual page 59 adjusting the idle speed it says pilot air screw setting 1 3/4, but on page 199 assembling the carburetor its says pilot screw turns out 2 3/4. which one should be followed, pls enlighten me kinda confusing,TIA
  2. Adrian Relato

    Yamaha T135hc Sniper Mx 1rp Service Manual Complete

    its has been deleted can you post it again tnx
  3. Adrian Relato

    Hard Shifting Stock Sniper Mx?

    i dont experience that on my bike bro only when its time for me to change oil but shifting is not that hard. I think you need to have that checked so you can avoid further damages and expensive maintenance cost it the future.
  4. Adrian Relato

    Hard Shifting Stock Sniper Mx?

    sometimes bro its really hard to diagnose if theres a prob. if you have a friend who also have mx try to compare. but you check what oil he's using., from that you can have your baseline. just an idea
  5. Adrian Relato

    Hard Shifting Stock Sniper Mx?

    no hard shifting from 2nd to 1st gear. sometimes bro its a matter of timing. what i experienced though is when im in 5th gear and i suddenly stop, and i need to go back to low gears i still have to move the bike forward a bit for it to kick in. i guess its normal in manual transmission but if...
  6. Adrian Relato

    Hard Shifting Stock Sniper Mx?

    projectdimpreza fully synthetic oil might cause prob in clutch lining depending on the brand of oil. Check with the label, repsol fully synthetic 10w 50 and 20w 50 is specially designed for wet clutches and also mobil 1 fully synthetic. so far i dont experience any prob with repsol. i havent...
  7. Adrian Relato

    Hard Shifting Stock Sniper Mx?

    bro mx owner here...did you already change your oil? i experienced that too i just change my oil..prob fixed..based on my observation and experience, yamalube is only good up to 700 km if you reached that shifting gears change dramatically contrary to what 3smechanic recommends. unless theres a...
  8. Adrian Relato

    Sniper Radiator Cover

    d2 ko lng nbili samin sa rizal, sn location mo dami dw n2 sa caloocan
  9. Adrian Relato

    All new 2011 Yamaha T135 (5 gears) Parts Catalog

    sir traxxas i was wondering if you can get service manual of sniper mx, tnx
  10. Adrian Relato

    Finally I Got A Rs For My Smx

    sir ask ko lng how much score mo sa RB v3, and sn mo nabili, meron ba ibang color. tnx..
  11. Adrian Relato

    Mga Magnanakaw Ng Motor

    un ang pinagtataka ko 2mons nila minanmanan then confirm may 2 complainant d parin hinuli, mahina mga parak
  12. Adrian Relato

    Mga Magnanakaw Ng Motor

    putol bro napanood ko na to, d nahuli
  13. Adrian Relato

    After 1st Tune-up

    gas consumption really depends on alot of factors, good for you your gas consumption runs low, yah since your not familiar with that troubleshooting bring it back to 3s shop.
  14. Adrian Relato

    After 1st Tune-up

    bro check the pilot air screw and the idle on the carb.it should be atleast 1 5́-8 turn maybe lack of air coming into the carb, if it doesnt work bring it back to motortrade wer you have it tuned up.
  15. Adrian Relato

    Mmda - Bawal Na Ang May Angkas (manila Area,philippines)*in Filipino Discussion

    this is unfair, pagpinatupad yan dapat magprotesta tau para maglabas ng TRO..
  16. Adrian Relato

    Sniper Mx Factory Settings Of Pilot Screw-a/f

    bro stock setting sniper mx according to 3s shop is 2 and a half turn. my dealer changed it to 7 turn dumb moron makes my bike run crazy so i switched it back to the original setting and it works fine for me. hope it helps
  17. Adrian Relato

    Sniper Mx Factory Settings Of Pilot Screw-a/f

    bro stock setting sniper mx according to 3s shop is 2 and a half turn. my dealing change it to 7 turn dumb moron so i switched it back to the original setting and it works fine for me. hope it helps
  18. Adrian Relato

    Engine stumbling at the twist of the throttle

    guys i was trying to backread some of the threads here coz seems like i was experiencing the same problem that you guys had. any news about it. mx user here just 6 mons old, 3k plus odo reading.this happend after i went to yzone have my bike tuned up, but unfortunately my bike is not running the...
  19. Adrian Relato

    Sniper Radiator Cover

    medyo mahal, coz i dont have time to go to caloocan.
Top